Setup


When using a Bed or Chair Mat, plug the RJ11 connector into the middle socket on the bottom of the controller.

When the Mat is pressed down, the light above the socket will flash to indicate contact. The controller will raise a call when the mat is released (Resident gets up from mat).




By default, Floor Mats are made with a USB type B connector which are incompatible with the Daisy Out of Bed Mat Controller. If you intend to use a Floor mat with this device, please request the custom modification for an RJ11 connector to be made when placing your order for the mat.


When using a Wet or Floor Mat, plug the RJ11 connector into the left socket on the bottom of the controller.

When the Mat is pressed down, the light above the socket will flash to indicate contact. The controller will raise a call immediately when contact is detected.